14
1
Set to the “
∞
” position.
2 Turn the power on.
3 Select the desired input source by using the input
selector buttons.
* The name of the selected input source will appear on
the display.
4 Select the speakers to be used.
* If you use two speaker systems, press both the A and B
switches.
5 Play the source. (For detailed information on the
tuning operation, refer to page 17.)
6
Adjust to the desired output level.
7 If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, or use the PURE DIRECT switch
(for RX-496 only). For details, refer to page 16.
Notes on using the input selector buttons
●
Note that pressing each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
●
The selection of TAPE 2 MONITOR cannot be canceled by
pressing another input selector button. To cancel it, press
TAPE 2 MONITOR again so that the “TAPE MON 2”
indicator disappears from the display.
When you select a button other than TAPE 2 MONITOR,
make sure that the “TAPE MON 2” indicator is not
illuminated on the display.
When you finish using this unit
Press the STANDBY/ON switch on the front panel again or
the STANDBY/ON key on the remote control transmitter to
turn this unit into the standby mode.
BASIC OPERATIONS
TO PLAY A SOURCE
