3 - 29
INSP
ADJ
REAR BRAKE PAD INSPECTION AND REPLACEMENT
• Remove the pad pin 6 and brake pads 7.
• Connect the transparent hose 8 to the
bleed screw 9 and place the suitable con-
tainer under its end.
• Loosen the bleed screw and push the cali-
per piston in.
CAUTION:
Do not reuse the drained brake fluid.
• Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
• Install the brake pad 0 and pad pin A.
OTE:
• Install the brake pads with their projections
a into the caliper recesses b.
• Temporarily tighten the pad pin at this
point.
• Install the caliper B and rear wheel C.
Refer to “FRONT WHEEL AND REAR
WHEEL” section in the CHAPTER 5.
• Tighten the pad pin D.
T
R
.
.
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)
• Install the pad pin plug E and protector
F.
T
R
.
.
Pad pin plug:
3 Nm (0.3 m • kg, 2.2 ft • lb)
Bolt (protector):
7 Nm (0.7 m • kg, 5.1 ft • lb)
