Zebra Technologies PrintServer Manual

A SERVICE OF

next previous

Installation

External PSII

PrintServer II User and Reference Guide 21

This illustration calls out the location of the parallel port and provides a blown up

illustration of the parallel port:

3. Secure the wire locks.

4. On the back of the PSII, insert a live 10BASE-T cable into the Ethernet connector.

5. Power on the printer.

An red status indicator blinks during the POST (Power On Self Test) and changes

to green when stabilized.

6. Press the test button located on the side of the

PSII. This prints out a configuration

label of PSII:

Note • To determine the minimum label width needed to print a PSII configuration

label, refer the following list of printhead resolutions:

• 600 dpi (1.25 inch)

• 300 dpi (2.50 inch)

• 200 dpi (3.69 inch)

• 150 dpi (5.0 inch)