Front Panel Controls
Front Panel LCD
23063L-003 Rev. 2 12/23/04 R110Xi/R170Xi User Guide 45
TEAR OFF
Adjusting the Tear-Off Position
This parameter establishes the position of the labels over the tear-off/peel-off bar
after printing.
Each press of an oval adjusts the tear-off position by four dot rows.
• Press the right oval to increase value.
• Press the left oval to decrease value.
Default: +0
Range: –120 to +120
PRINT MODE
Selecting Print Mode
Print mode settings tell the printer the method of label delivery that you wish to use.
Be sure to select a print mode that your hardware configuration supports because
some of the selections displayed are for optional printer features.
• Press either oval to display choices.
Default: Tear-Off
Selections: Tear-Off, Peel-Off, Cutter, Applicator, Rewind
Note • Only Tear-Off mode is supported.
MEDIA TYPE
Setting Media Type
This parameter tells the printer the type of media that you are using. Selecting
continuous media requires that you include a label length instruction in your label
format (
^LLxxxx if you are using ZPL or ZPL II).
When non-continuous media is selected, the printer feeds media to calculate label
length (the distance between two recognized registration points of the inter-label
gap, webbing, or alignment notch or hole).
• Press either oval to display choices.
Default: Non-Continuous
Selections: Continuous, Non-Continuous
SENSOR TYPE
Setting the Sensor Type
This parameter tells the printer whether you are using media with a web (gap/space
between labels, notch, or hole) to indicate the separations between labels or if you
are using media with a black mark printed on the back. If your media does not have
black marks for registration on the back, leave your printer at the default (web).
• Press either oval to display other choices.
Default: WEB
Selections: WEB, MARK
Table 7 • Standard LCD Displays (Page 2 of 16)
Parameter Action/Explanation
