25
English
4. SET UP
■ ADJUSTING THE PLAY OF
THROTTLE WIRE
After connecting the main pipe,
make sure that the end of the
throttle wire is properly inserted
into the cable adjuster. If the end
of the throttle wire goes up into
the cable adjuster, the engine
rotation will not decrease even if
the throttle lever is turned back,
posing a risk of danger.
• Loosen the knob of the air cleaner
cover and remover the cover.
(1) Knob
(2) Air cleaner cover
• The proper play of the throttle wire
is 1 to 2 mm when the wire sleeve
extending from the cable adjuster
is lightly pulled with your fingers
after the throttle lever has been
turned back. If the play of the
throttle wire is too large or too
small, loosen the lock nut and
readjust the position of the cable
adjuster.
(1) Cable adjuster
(2) Throttle wire
(3) Joint
(4) Throttle shaft
• The play of the throttle wire
increases when the cable adjuster
is turned clockwise. The play of
the throttle wire decreases when
the cable adjuster is turned
counterclockwise.
• After adjusting the play of the
throttle wire, tighten the lock nut to
fix the cable adjuster.
(1) Wire sleeve
(2) Lock nut
(3) Cable adjuster
When you bend the flexible shaft, the
amount of play of the throttle wire
changes. Adjust the play of the
throttle wire while keeping the flexible
shaft in an actual working position.
IMPORTANT
갔는지 확인해 주십시오. 와이어의 선
전이 줄어들지 않아 위험합니다.
오.
도면 적당합니다. 유격이 너무 크거
의 위치를 재조정해 주십시오.
아집니다.
침쇠를 고정해 주십시오.
와이어의 유격량이 변화합니다. 유격
시와 가까운 상태로 해 주십시오.
