Chapter 30 Configuration: Management
GS1900 Series User’s Guide
198
Figure 181 Configuration > Management > SNMP > User > Add/Modify
The following table describes the labels in this screen.
30.3.8 The Trap Screen
Use this screen to configure the Trap settings. Click Configuration > Management > SNMP >
Trap to open this screen.
Table 163 Configuration > Management > SNMP > User > Add/Modify
LABEL DESCRIPTION
SNMP User
User Name Enter a string identifying the user name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Group Name Enter a string identifying the group name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Auth Protocol Select the authentication protocol that this entry belongs to. Possible authentication
protocols are:
• MD5: An optional flag to indicate that this user uses MD5 authentication protocol.
• SHA: An optional flag to indicate that this user uses SHA authentication protocol.
The value of the security level cannot be modified if the entry already exists. That means
you must first ensure that the value is set correctly.
Auth Password Enter a string identifying the authentication password phrase. For MD5 authentication
protocol, the allowed string length is 8 to 32. For SHA authentication protocol, the allowed
string length is 8 to 32. The allowed content is ASCII characters from 33 to 126.
Priv password Enter a string identifying the privacy password phrase. The allowed string length is 8 to 64
and the allowed content is ASCII characters from 33 to 126.
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.
