Chapter 33 Command Examples
GS-3012/GS-3012F User’s Guide
247
33.7 Example no Commands
These are the commonly used command examples that belong to the “no” group of
commands.
33.7.1 no mirror-port
Syntax:
no mirror-port
Disables port mirroring on the switch. An example is shown next.
Figure 141 no mirror-port Command Example
33.7.2 no trunk
Syntax:
no trunk <T1|T2|T3|T4|T5|T6>
no trunk <T1|T2|T3|T4|T5|T6> lacp
no trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
An example is shown next.
• Disable trunk one (T1).
• Disable LAPC on trunk three (T3).
• Remove ports one, three, four and five from trunk five (T5).
Figure 142 no trunk Command Example
sysname(config)# no mirror-port
where
<T1|T2|T3|T4|T5|T6>
Disables the trunk group.
<T1|T2|T3|T4|T5|T6> lacp
Disables LACP in the trunk group.
<T1|T2|T3|T4|T5|T6>
interface <port-list>
Removes ports from the trunk group.
sysname(config)# no trunk T1
sysname(config)# no trunk T3 lacp
sysname(config)# no trunk T5 interface 1,3-5
