Filter
Top Products
2
Getting started ....................
2.1 Set-up
You must insert your SIM card
(1)
to make phone calls.
Inserting the SIM card Removing the SIM card
16
Installing the battery Removing the battery
(1)
Check with your network operator to make sure that your SIM card
is 3V compatible. The old 5 Volt cards can no longer be used. Please
contact your operator.
Line switching
(1)
: indicates the selected line.
GPRS connection status (Blue - Activated).
Shown only in no ciphering mode while calling, sending/receiving
SMS.
Multimedia player active.
USB cable connected.
Reception of a message in progress.
Sending a message.
Silence mode: your phone neither rings, beeps nor vibrates
except for the alarms (see page 69).
Message unread
Message list is full: your terminal cannot accept any new
messages. You must access the message list and delete at least one
message on your SIM card.
Preferred tariff areas
(1)
.
Antenna off mode.
A2DP connected.
15
(1)
Contact your network operator to check service availability.
Insert and click the battery into place,
then close the telephone cover.
Unclip the cover, then remove the
battery.
Place the SIM card with the chip facing
downwards and slide it into its housing.
Make sure that it is correctly inserted.
To remove the SIM card, lift the bottom
up a bit and slide it out in the directions
of the arrows. Please power off your
phone before you remove the SIM card.
600_UM_GB-03-03-09:600_UM_GB_15-01-09 3/3/2009 2:55 PM Page 15