ALCATEL Mobile Phones OT-708A Cell Phone User Manual


 
17 18
2
Getting started .......................
2.1 Set-up
Inserting and removing the SIM card
(1)
You must insert your SIM card to make phone calls.
Place the SIM card with the chip facing downwards and slide it into its housing. Make
sure that it is correctly inserted. To remove the card, press it and slide it out. Please
power off your phone before you remove the SIM card.
(1)
Check with your network operator to make sure that your SIM card is 3V
compatible. The old 5 Volt cards can no longer be used. Please contact your
operator.
Charging the battery
Connect the battery charger
Charging may take about 20 minutes if the battery is flat.
Be careful not to force the plug into the socket.
Make sure the battery is correctly inserted before connecting the charger.
The mains socket must be near to the phone and easily accessible (avoid electric
extension cables).
When using your telephone for the first time, charge the battery fully (approximately
3 hours). You are advised to fully charge the battery ( ).
The charge is complete when the animation stops. Only use Alcatel chargers.
Insert and click the battery into place, make sure battery connecting with battery
connector, then close the telephone cover.
Unclip the cover, then remove the battery.
Removing or installing the back cover
Installing and removing the battery