American Telecom SL PTG012 Cell Phone User Manual


  Open as PDF
of 5
 
AMERI*CAN TELECOM INC.
Technical Document
SL PTG012 Installation Instructions Page 4
2. Position the enclosure on the wall in the location it will be mounted. Ensure that
it’s at the appropriate height, and level; mark the position of the four mounting
holes, forming a rectangle 26” by 4 3/8”. Refer to the illustration below. Note: If
the wall is wallpapered, use a razor to cut the area around the mark before
drilling.
3. Use a 1/8” bit to drill the pilot holes for the wall anchors to mount the enclosure.
4. Insert the anchors into the drilled holes. For vertical mounting, install two screws
in the side hanger holes and for horizontal hanging, place the two screws in the
top hanger holes.
5. Hang the Enclosure on the “key holes” located on the rear of the Enclosure.
Install the two remaining screws in holes located in the storage pockets of the
enclosure.
 previous