Filter
Top Products
16
- 16 -
OPERATION
Using the Ringer Off/Low/Hi Switch
The
Off/Low/Hi switch
can be used to set the sound level of the ringer.
1. Set the
Off/Low/Hi
switch to the
Hi
position for normal operation.
2. Set the
Off/Low/Hi
switch to the
Low
position for less sound.
3. Set the
Off/Low/Hi
switch to the
Off
position for no sound.
Setting the Tone/Pulse Switch
Your telephone can operate in tone or pulse dialing mode.
1. Set the
T/P
switch to the desired position. If you're not sure which service
you have, set the
T/P
switch to the tone,
T
position. See Figure 2
2. Lift the handset and dial your number. If the dial tone continues, you have
pulse service, set the
T/P
switch to the pulse,
P
position.
Making Calls
To make a call, lift the handset or press the
SPK
button once.
1. When dial tone is heard, dial the desired number.
2. The handset icon as well as the number being dialed will be indicated in
the display.
3. Hang up when you finish your call. Within 10 seconds, the display will re-
turn to Stand-By Screen mode.
Receiving Calls
When the telephone rings, the
RINGER
LED will flash.
Important: Do not answer incoming calls until the second ring occurs.
This is necessary so that the Caller ID information can be received.
1. Lift the handset or press the
SPK
button once.
2. The
HANDSET
icon as well as the Caller-ID information will be displayed
for the duration of the call.
3. If necessary, adjust the
VOLUME
control located on the right side of the
telephone headset to a comfortable receive level. See Figure 2
4. Hang up when you finish your call. Within 10 seconds, the display will re-
turn to the Stand-By Screen.
Using the Speakerphone
You can make or receive calls using the speakerphone.