Filter
Top Products
4
To install your Tablet PC into the bump case, position the
case face down as shown in Figure 3. Open the side flap of
the case. The flap is secured by a long strip of Velcro® that is
attached to the back of the bump case. Note that the left side
of the case is open for port access, but the system cannot be
inserted or removed from that side.
System with high-capacity battery installed:
Remove the foam bumper that is attached to the Velcro strip
on the flap prior to installing a system with a high capacity
battery. Retain the bumper for when you use the system with
a main battery.
Slide the system into the bump case, with the screen facing
the open window. (See Figure 3). Reattach the flap to the
side of the case.
Figure 3. Inserting Tablet PC into Bump Case
Bump case
(rear, with side flap open)
Tablet PC
Battery strap
FPC58-1044-01 Bump Case.fm Page 4 Monday, December 8, 2003 1:28 PM