Filter
Top Products
FOR YOUR SAFETY:
• For Personal Safety, remove house fuse or open
circuit breaker before beginning installation.
Failure to do so could result in serious injury
or death.
• Be sure your cooktop is installed properly by a
qualified installer or service technician.
• To eliminate the risk of burns or fire by reaching
over heated surface elements, cabinet storage
located above the surface units should be avoided.
If cabinet storage space is to be provided, the risk
can be reduced by installing a range hood that
projects horizontally a minimum of 5″ beyond the
bottom of the cabinets. Cabinet installation above
the cooktop may be no deeper than 13″.
2
Before you begin—Read these instructions completely and carefully.
IMPORTANT—Save these instructions for local inspector’s use.
IMPORTANT—OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer—Be sure to leave these instructions with the Consumer.
Note to Consumer—Keep these instructions for future reference.
Note—This appliance must be properly grounded.
ATTENTION INSTALLER: ALL COOKTOPS MUST BE HARD WIRED (DIRECT WIRED) INTO
AN APPROVED JUNCTION BOX. A “PLUG AND RECEPTACLE” IS NOT PERMITTED ON
THESE PRODUCTS.
This appliance must be properly grounded. See “Electrical Connections,” page 7.
WARNING
!
If you have questions concerning the installation
of this product, call the GE Answer Center
®
Consumer Information Service at 800.626.2000,
24 hours a day, 7 days a week or visit our website
at: Monogram.com.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty. See
the Owner’s Manual for warranty information.
If you received a damaged cooktop, you should
contact your dealer.
For Monogram local service in your area,
1.800.444.1845.
For Monogram Service in Canada,
1.888.880.3030.
For Monogram Parts and Accessories,
call 1.800.626.2002.
• Make sure the cabinets and wall coverings around the
cooktop can withstand the temperatures (up to 200°F)
generated by the cooktop.
• The cooktop should be easy to reach and lighted with
natural light during the day.
• Always disconnect the electrical service to the cooktop
before repairing or servicing the cooktop. This can be
done by disconnecting the fuse or circuit breaker.
Failure to do this could result in a dangerous or fatal
shock. Know where your main disconnect switch is
located. If you do not know, have your electrician
show you.
Check local building codes for the proper method
of cooktop installation. Local codes vary. Installation,
electrical connections and grounding must comply
with applicable codes.
This appliance must be supplied with the proper voltage and frequency, and connected to an
individual, properly grounded branch circuit, protected by a circuit breaker or a time delay fuse as noted
on the rating plate.
We recommend you have the electrical wiring and hookup of your cooktop connected by a qualified
electrician. After installation, have the electrician show you where your main range disconnect
is located.
Wiring must conform to the National Electrical Code. You can get a copy of the National Electrical Code,
ANSI/NFPA No. 70-Latest Edition, by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
The cooktop conduit wiring is approved for copper wire connection only, and if you have aluminum house
wiring, you must use special UL approved connectors for joining copper to aluminum.
You must use a two-wire, three conductor 208/240VAC, 60 Hertz electrical system. A white (neutral) wire
is not needed for this unit. The cooktop must be installed in a circuit that does not exceed 125 VAC nominal
to ground. Refer to the rating plate on your cooktop for the KW rating for your cooktop.
Electrical Requirements