Filter
Top Products
It is extremely important that you keep the T-Seal
clean & free of sand, dirt, hair, lint, and other
debris.
To clean the T-Seal remove it from the case.
Wash T-Seal in warm fresh water, ensuring all
debris is cleaned from the T-Seal.
*Strong detergents, soaps, and chemicals MUST
NEVER be used to clean the case or the T-Seal.*
Allow T-Seal to air dry. Once dry install back into
the case. Please refer to the “How to install /
replace your T-Seal” on how to properly install
the T-Seal.
For long term storage, store in a plastic bag out
of direct sunlight.
Cleaning & Storing the T-Seal
H2O Audio:
1.800.708.6080
858.623.0339
support@h2oaudio.com
www.h2oaudio.com
iN3 - 76 20071112
Î
The misaligned T-Seal becomes pinched between
the base and lid (as Shown) creating an opening in
the case that will cause the case to flood.
This T-Seal is correctly seated in a closed
case, sealing the case and protecting the
iPod from water.
Incorrect
Correct
5. Gently close lid and lock latch. The lid should close
without any resistance. If you experience any resistance
when closing the case please call customer service
immediately at 1.800.708.6080 before using the case.
6. Visually inspect the outside of the case and ensure
the T-seal is installed correctly. If the T-Seal is dirty, out
of alignment, twisted or pinched in any way it will
compromise the integrity of the case and should not
be used.
How to install / replace the T-Seal