Filter
Top Products
Removing and Replacing Components
2. Rotate the slot in the enclosure lid lever to the unlocked position (1), as indicated by the
open padlock embossed in the lever.
3. Pull the lever toward the front of the enclosure (2).
4. Lift the lid off the enclosure (3).
To replace the lid:
1. Position the lid on the chassis so that the peg on the chassis (1) fits into the hole under the
lid lever, and the flanged pegs (2) on the inner edge of the lid fit into slots (3) on the side
of the enclosure.
2. Press the lid lever fully down.
3. Rotate the slot in the lid lever to the locked position.
Midplane Board
1. Remove the fan assemblies.
2. Remove the power supply units.
3. Remove the controller module.
HP StorageWorks Modular Smart Array 20 Maintenance and Service Guide 3-7