Filter
Top Products
7
E Face the front glass of the marine case upwards, and open the
buckles to remove the camera, while paying attention not to let water
droplets at the O-ring or buckles enter the case.
F Upon removing the camera, close the marine case again while paying
attention not to allow water droplets enter the case, followed by
tightening all the buckles.
G Final salt removal
Submerge the marine case in fresh water for at least 1 hour to
remove salt.
• Shaking the case body in the upward and downward directions and rinsing it
helps to remove salt more effectively.
• Make sure the marine case is fully submerged in the fresh water.
H Remove the marine case and wipe off water droplets on the case
surface using a dry cloth. Then open the buckles to allow the inside
and outside of the case to dry thoroughly.
• Temperature, humidity, water temperature, salinity and other conditions
vary according to the environment of use.
Front glass
Memo
Memo
WR-MG88_EN_A5.fm Page 7 Monday, May 14, 2007 8:52 AM