Filter
Top Products
20 21
Adjusting the Volume
The volume buttons on the left topside of the phone
can be used to adjust earpiece, ringer, key beep
volumes and message volume (SMS message
volume). The upper button increases and the lower
button decreases the volume.
You may adjust the earpiece volume while you are
in a call.
Adjust the ringer volume while the phone is
ringing.
The ringer volume can also be adjusted through
Menu feature.
If you adjust the ringer volume to minimum, the
LCD displays “-Ringer Off-” and you will not hear
the ringer sound.
The key beep volume is adjusted through Menu
feature.
The message volume is adjusted through Menu
feature.
Power Save Mode
When the phone is in an area without service for 15
minutes, it stops searching for service and enters
into the Power Save Mode. When your phone
activates this feature, “Power Save” is displayed on
your screen. The phone automatically checks for
service periodically or you can check manually by
pressing any key.
Signal Strength
The call quality depends on the signal strength in
your area. The phone displays the current strength
as the number of bars next to the signal strength
icon: the more the bars, the better the signal
strength. If the signal quality is poor, try moving the
phone. If you are in a building, the reception may be
better near a window. For maximum reception,
make sure that the antenna is fully extended.
Emergency Dialing
As long as your phone is registered on the system,
you can place calls to emergency number 911 -
even if your phone is locked or restricted.
1. Press then .
or
1. Press and hold (for more than 2 seconds).
Speed Dialing (see “Dialing Number
from Your Phone Book” on page 29.)
Speed dialing is a convenient feature, allowing you
to make phone calls quickly and easily. Your phone
recalls the phone number from your personal
directory, displays it briefly, and then dials it.
1. Enter memory location number (1 to 199).
2. Press . The phone will recall the telephone
number from memory, display it, and then dial it.
3. Press and hold the last digit of the memory
location number.