Only qualified personnel should install
the device in a vehicle. Faulty
installation or service may be
dangerous and may invalidate your
warranty. Check regularly that all
wireless device equipment in your
vehicle is mounted and operating
properly. Do not store or carry
flammable liquids, gases, or explosive
materials in the same compartment
as the device, its parts, or accessories.
Remember that air bags inflate with
great force. Do not place your device
or accessories in the air bag
deployment area.
Potentially explosive
environments
Switch your device off in any area with
a potentially explosive atmosphere,
for example near petrol pumps at
service stations. Sparks in such areas
could cause an explosion or fire
resulting in bodily injury or death.
Observe restrictions in fuel service
stations, storage, and distribution
areas; chemical plants; or where
blasting operations are in progress.
Areas with a potentially explosive
atmosphere are often, but not always,
clearly marked. They include areas
where you would be advised to switch
your vehicle engine off, below deck on
boats, chemical transfer or storage
facilities, and where the air contains
chemicals or particles such as grain,
dust, or metal powders. You should
check with the manufacturers of
vehicles using liquefied petroleum
gas (such as propane or butane) to
determine if this device can be safely
used in their vicinity.
Certification information (SAR)
This mobile device meets guidelines
for exposure to radio waves.
Your mobile device is a radio
transmitter and receiver. It is
designed not to exceed the limits for
exposure to radio waves
recommended by international
guidelines. These guidelines were
developed by the independent
scientific organisation ICNIRP and
include safety margins designed to
assure the protection of all persons,
regardless of age and health.
The exposure guidelines for mobile
devices employ a unit of
measurement known as the Specific
Absorption Rate or SAR. The SAR limit
stated in the ICNIRP guidelines is 2.0
watts/kilogram (W/kg) averaged over
10 grams of tissue. Tests for SAR are
conducted using standard operating
positions with the device transmitting
at its highest certified power level in
100