Nokia 6125 Cell Phone User Manual


 
18Copyright © 2006 Nokia. All rights reserved.
For availability of approved enhancements, please check with your dealer.
1. Connect the charger to a standard wall outlet.
2. Insert the charger plug into the round jack in the bottom of the
phone. If the battery is completely discharged, it may take a few
minutes before the charging indicator appears on the display or
before any calls can be made.
3. Disconnect the charger from the phone when the battery is fully
charged.
You can use the phone while the charger is connected. The charging time
depends on the charger and the battery used. For example, charging a
BL-4C battery with the AC-3 charger takes approximately 2 hours and
20 minutes while the phone is in the standby mode.
Memory card installation
Use only compatible microSD cards with this device. Other memory cards do not fit in the memory
card slot and are not compatible with this device. Using an incompatible memory card may damage
the memory card as well as the device, and data stored on the incompatible card may be corrupted.
Use only memory cards approved by Nokia. While Nokia conforms to the approved
industry standards in the use of memory cards, full compatibility across all brands cannot
be assured due to product quality varying among third party manufacturers.
You can use a memory card to extend the memory of the Gallery. See Gallery p. 80. You can insert or change
the memory card without turning the phone off.
Important: Do not remove the memory card in the middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage the memory card as well as the device, and data
stored on the card may be corrupted.