Filter
Top Products
19
Display 45 – Toggle transmitter functionality
**************
* *
*TRANSMITTER *
* XXXXXXXX * XXXXXXXX ENABLED or DISABLED
* *
**************
This display has no effect in 7110 phone, irrespective of the displayed status the
transmitter is always switched on.
When selected, this display disables transmitter functionality if enabled and vice
versa. New setting is valid until next power off or until new execute of this
display.
This FTD can be used to simulate easily situations when the MS can hear the network
(i.e. receiving signal is good enough), but the network can not receive any messages
from the MS.
Location updating attempts or MO call establishment attempts can be failed (random
access failure) by this FTD and field testing of these failures is much easier now.
Next periodic location updating can be checked from the display 10 (chapter 3.1.10)
by taking the difference of current T3212 counter value and T3212 timeout value.
Display 51 – SIM information
++++++++++++++ ##############
+aaa bbb ccc + #VSel Bau SAl#
+ dddddddd + #SCond CStop#
+ f g hh ii + #PIN12 PUK12#
+ j kkkk + # ATR FE/PE #
++++++++++++++ ##############
aaa SIM voltage selection type (5, 3 or 3/5)
bbb SIM baudrate (372, 64, 32 or 0)
ccc Clock stop allowed, Yes or No
dddd Clock stop condition, Up/Down/xxxxxxxx if no preferred level
f PIN1 attempts left (0,1,2,3)
g PIN2 attempts left (0,1,2,3)
hh PUK1 attempts left (0-10)
ii PUK2 attempts left (0-10)
j ATR retransmission counter (0-9)
kkkk Transmission frame/parity errors,
FE/PE + hexadecimal count
Display 54 – Block display 1
++++++++++++++ ##############
+aa bb aa bb+ #ResF1 ResF2#
+aa bb aa bb+ #ResF3 ResF4#
+aa bb aa bb+ #ResF5 ResF6#
+aa bb aa bb+ #ResF7 ResF8#
++++++++++++++ ##############
1. row: Block set 1, block set 2
2. row: Block set 3, block set 4
3. row: Block set 5, block set 6
4. row: Block set 7, block set 8
aa Number of reserved blocks
bb Number of free blocks in worst case