Filter
Top Products
3. Insert the card into the
microSD card slot with
the contact surface
facing down, and press it
until it locks into place.
4. Replace the battery.
5. Replace the back cover.
Remove the microSD card
1. Remove the back cover of the device.
2. Remove the battery.
3. Press the microSD card slightly to release the lock, and pull
the card out.
Charge the battery
Your battery has been precharged, but the charging levels
may vary.
1. Connect the charger to a wall outlet.
2. Connect the charger to
the device.
3. When the battery is
fully charged,
disconnect the
charger from the
device, then from the
wall outlet.
You also may charge the
battery with a USB cable with power from a computer.
1. Connect the USB cable to the USB port of a computer and
to your device.
2. When the battery is fully charged, disconnect the USB
cable.
If the battery is completely discharged, it may take several
minutes before the charging indicator appears on the display
or before any calls can be made.
The charging time depends on the charger used. Charging a
BL-6Q battery with the AC-8 charger takes approximately 1
hour 25 minutes while the phone is in the home screen mode.
Antenna
Your device may have internal and external
antennas. As with any radio transmitting
device, avoid touching the antenna area
unnecessarily while the antenna is transmitting
or receiving. Contact with such an antenna
affects the communication quality and may
cause the device to operate at a higher power
level than otherwise needed and may reduce
the battery life.
The figure shows the antenna area marked in
grey.
Strap
1. Remove the back cover.
Get started
© 2009 Nokia. All rights reserved. 13