Filter
Top Products
Defining WLAN connection settings
6
Copyright © 2006 Nokia. All rights reserved.
• EAP plug-in settings — If you selected EAP, you must
also define these settings. See page 7 for more
information.
• TKIP encryption — To enable TKIP encryption, based
on transient keys changed often enough to prevent
misuse, select Allowed. All devices in the wireless
LAN must either allow or prevent the use of TKIP
encryption.
If you selected 802.1x as the WLAN security mode,
define the following in WLAN security sett.:
• WPA mode — Select EAP if you want to use an EAP
module for authentication. If you select Pre-shared
key, type the password (also called a master key) in
the field. Note that the same key must be entered in
the wireless LAN access point.
• EAP plug-in settings — If you selected EAP, you must
also define these settings. See page 7 for more
information.
Note: 802.1x authenticates and authorizes
devices to access a wireless network, and
prevents access if the authorization
process fails.
If you selected WEP as the WLAN security mode, define
the following in WLAN security sett.:
• WEP key in use — Select which WEP key is used (#1-
#4).
• Authentication type — Select Open or Shared.
• WEP key settings — The remaining settings are
defined here:
WEP encryption — Select the desired WEP encryption
key length. Supported options are 64 and 128 bits.
The more bits there are in the key, the higher the
level of security. WEP keys consist of a secret key
and a 24-bit initialization vector. For example, some
manufacturers refer to the 104-bit key as a 128-bit
key (104+24). Both keys offer the same level of
encryption and are therefore interoperable.
Nokia_E60_Using_WLAN_en_1.fm Page 6 Monday, June 5, 2006 6:04 PM