Filter
Top Products
Settings
109
Homepage—Depending on the access point you are setting
up, enter the web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type—Select the internet protocol type to use:
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address—In Primary DNS address, enter the IP
address of the primary DNS server. In Secondary DNS
address, enter the IP address of the secondary DNS server.
Contact your internet service provider to obtain these
addresses.
Proxy server address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data connection—If you select When available
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to establish a packet
data connection. If you select When needed, the device
uses a packet data connection only if you start an
application or action that needs it.
Access point—The access point name is needed to use your
device as a packet data modem to your computer.
Data call
The data call settings affect all access points using a GSM
data call connection.
Online time—Set the data calls to automatically
disconnect after a time-out if there is no activity. To enter
a time-out, select User defined, and enter the time in
minutes. if you select Unlimited, data calls are not
automatically disconnected.
SIP settings
SIP (session initiation protocol) settings are needed for
certain network services using SIP, such as video sharing.
You may receive the settings in a special text message
from your service provider. You can view, delete, or create
these setting profiles in SIP settings.