Filter
Top Products
13
CHAPTER 3
Using Phone Connections
After you install the phone files and configure a link between your handheld and
your phone, you are ready to make connections. Depending on the type of link you
configured (infrared, cable, or Bluetooth™), refer to the appropriate set of
instructions below.
By default, your handheld disconnects automatically when the connection is
inactive for one minute.
If you used the Network Preferences screen to set up multiple network service
profiles, you can choose a different service when you establish a connection. See
the electronic handbook that came with your handheld for information on setting
up multiple network service profiles.
To make an infrared connection:
1.
Turn on your handheld and your mobile phone.
2.
Activate the infrared port on your phone.
3.
Align the infrared port on your handheld with the infrared port on your phone.
4.
Launch the application that requires the phone connection.
For example, to access e-mail, launch the Palm™ VersaMail™ application.
To make a cable connection:
1.
Connect the cable to your handheld and mobile phone.
2.
Turn on your handheld and your mobile phone.
3.
Launch the application that requires the phone connection.
For example, to access e-mail, launch the Palm VersaMail application.
To make a Bluetooth connection:
1.
Turn on your handheld and your mobile phone.
2.
Activate Bluetooth on your handheld and phone.
3.
Make sure your phone is within 10 meters (approximately 30 feet) of your
handheld.
4.
Launch the application that requires the phone connection.
For example, to access e-mail, launch the Palm VersaMail application.