Sanus Systems NFV49 Cell Phone User Manual


  Open as PDF
of 4
 
Step 2: Attach the Rear Supports
Thread an Allen Bolt (i) through a Washer (j), through the middle hole in a Rear Support (e), through the middle hole in a Three Hole
Plate (c) and into the middle Steel Cross Tube (b). See Diagram 2 for assistance. Repeat the process until all 4 middle Allen Bolts, the 4
accompanying Washers, and the Rear Supports are attached to the middle Steel Cross Tubes.
Next, thread an Allen Bolt through each hole of the Wire Strap (h), the Rear Support, each outer hole of the Three Hole Plate and into
each outer Steel Cross Tube. See the Detailed View of Diagram 2 for assistance. Proceed to tighten all 12 Allen Bolts with the Allen
Key (m).
Diagram 2
Detailed View
b
c e
j i h
Note: The Rear Supports should be positioned so the set of three holes closest
to the edge is at the top and so the horizontal slots face the front frame.
Step 3: Add Glass Shelves
Install the Glass Shelves (d) so that the back of each shelf fits into the slot in the Rear Support (e) and the front of the shelf sits down
into the groove in the Front Frame (a). See Diagram 3 for assistance.
Diagram 3
a
e
d
slot
 previous