Filter
Top Products
SECTION 4
PROGRAMMING INSTRUCTIONS
1 Hardware Setup
The software programming setup requires a PC (386 type or higher) and the bootadaptor kit. The boot adaptor
kit consists of bootadaptor, cables and power supply.
• Connect RS232 cable from bootadaptor to com-port of PC (com 1 or com 2)
• Connect power supply (9V) to bootadaptor
• Connect bootadaptor to CMDX2000
2 Software setup
The software is distributed automatically after registration ofthe bootadaptor. Install the software into a dedicated
directory on the PC. It is ADVISABLE to perform the software programming ONLY starting from DOS, not under
Windows. If starting under windows, there is a slight chance that the windows program, still running on the
background, causes interruptions which might prove to be fatal.
Following files are available :
• swupinst.exe : this program enables you to choose language, to check com-port and to check connection to
the CMDX2000
• swup.ini this file contains language setting and com-port setting (can be changed from swupinst.exe or by
using editor program)
• langgrpX.xbi : each langgrpX.xbi file contains the full software package for a certain language group, when
starting the programming the correct choice of language group has to be made by operator
• swup.exe : start program for software programming, following options are possible :
– swup.exe /i : information on the software version is shown
– swup.exe /h : a small helpfile is shown
– swup.exe langgrpX.xbi : starts the software programming sequence for a language group.
3 Programming instructions :
•
Make sure a battery is in the CMDX2000.
• Make sure the bootadaptor is powered.
• Connect CMDX2000 to bootadaptor and check proper connection from bootadaptor to PC.
• Start PC under DOS, or exit windows.
• Start software programming sequence with instruction: swup.exe langgrpX.xbi (X = number of language
group, depending on available language group files).
• The software update will now be performed automatically, no further intervention is needed.
9