Filter
Top Products
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation of this device is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: Change or modication not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
NOTE: This device has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and the receiver.
• Connect the device into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modications not expressly approved by the grantee
of this device could void the user’s authority to operate the equipment.
RF Exposure warning
This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed
to provide a separating distance of at least 20 cm from all persons and
must not be co-located or opearating in conjuction with any other antenna
or transmitter. End users and installers must be provided with antenna
installation instructions and transmitter operating conditions for satisfying RF
exposure compliance.
Part 68 Information
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. On the underside of this equipment is a label that
contains, among other information, a product identier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the
telephone company.
A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A compliant telephone cord and modular
FEDERAL COMMUNICATIONS COMMISSION STATEMENT
18