Filter
Top Products
– 3 –
Install the battery pack
Charge the battery pack for at least 12-15 hours before
plugging the phone line into your phone.
1
Press in on the battery cover
release and slide the cover down
until it comes off.
2
Connect the battery pack
connector observing the correct
polarity (black and red wires) to
the jack inside the battery
compartment.
Do not exert any force on this
connection. It could cause damage to
the battery or to the handset. The
plastic connectors will fit together in
only one way.
Once you are certain that you have
made a good connection, then insert
the battery pack into the battery
compartment. Do not pinch the wires.
3
Securely close the battery
compartment cover by sliding it
until it snaps into place.
4
Place the handset in the charging
cradle.
When the battery is charged, the LCD
will display “
Initializing...”
for 5 to 10 seconds.
Use only the Uniden battery
(BP-490) supplied with your
phone. Replacement batteries
are also available through the
Uniden Parts Department.
(See page 2)
UZ624BT (DCX490) 9/17/01 11:48 AM Page 3