Filter
Top Products
– 5 –
To set up additional handsets
Follow the simple steps to register your new additional handset.
1
Check that the phone is not in use (including the intercom),
and make sure that the handset is not in the base unit.
2
Press and hold the find handset key on the base
for 5 seconds.
- The charge/voice mail LED will start flashing to tell you
that the system is in the registration mode.
3
Place the NEW (the 3rd) handset in the charging cradle of the
base unit.
- The handset beeps to tell you that the registration has
finished.
Resetting the handset
This feature allows you to clear (erase) all the selections and
settings of the handset. After you have reset the handset, you
must change the digital security code and re-register the
handset before use.
1
Press menu/enter key.
2
Press ▲ or ▼ and select “Handset Reset”.
3
Press menu/enter, “No?” appears on the display.
4
Press ▲ or ▼ to change the selection.
- “Yes” is to reset and “No” is to exit this mode.
5
Press menu/enter to confirm your selection.
6
Wait 5 to 10 seconds for the handset to complete the reset.
(“Initializing. . .” appears on the display.)
7
When the reset is complete, the LCD will display
“Handset is not registered”.
UZ624BT (DCX490) 9/17/01 11:48 AM Page 5