2 –Pump 18-Station Controllers Chapter 4: Operation 32 of 44
9. Put the standby pump online by briefly touching its icon. The icon changes codes to
show the new status, and the system begins using the pump. In addition, all “Station
Operator” and “Station Setup” screens show the new pump assignment.
Standby Pump Errors
If the error message tells you to disable the source pump and/or the standby pump, touch
RETURN at this screen, then PUMP STATUS at the “Pump Setup” screen. Take the pumps
offline and then return to the “Transfer to Standby Pump” screen.
If the error message tells you that the standby pump has stations assigned, you must either use
a different standby pump or you must remove the pump assignment for all stations assigned
to the standby pump. To remove the assignments, complete the following steps:
1. Touch BACK at the “Standby Pump” screen, and then touch Menu then STATION
STATUS.
2. Touch and hold a station icon to get to the “Station Operator” screen.
3. Then touch STATION SETUP to go to the “Station Setup” screen.
4. Use PREVIOUS and NEXT to review all pump assignments.
5. Where necessary, choose ASSIGNED TO PUMP to set station assignments to 0
(unassigned). Then return to the “Transfer to Standby Pump” screen.
6. Touch left side pump value and enter the number of the pump whose hoppers are to be
transferred.
7. Touch right side pump value and enter destination pump number.
Filter cleaning
Our pumps have two options available for filter cleaning; these are vacuum pulse or
compressed air filter cleaning. Touching the ENABLE/DISABLE button located in the
lower left hand corner of the pump setup screen will allow the operator to turn on/off these
two options or disable the filter cleaning option altogether.
Note: Each type of filter cleaning requires optional equipment that must be purchased and
installed prior to enabling this option.
