Publication 1794-6.5.12 - September 2011
Install Your FLEX I/O Input Module 13
Mount on a Panel or Wall
Installation of a FLEX system on a wall or panel consists of:
• laying out the drilling points on the wall or panel.
• drilling the pilot holes for the mounting screws.
• mounting the adapter mounting plate.
• installing the terminal base units and securing them to the wall or panel.
If you are installing your module into a terminal base unit that is already
installed, proceed to the section, Mount the FLEX I/O Module on the
Terminal Base Unit, on page 14.
Use the mounting kit Cat. No. 1794-NM1 for panel or wall mounting.
To install the mounting plate on a wall or panel:
(1.4)
35.5
0
1
7
2
3
4
6
7
8
9
2
+
2
+
1
2
3
4
45323
Millimeters
(Inches)
Description Description
1 Mounting plate for adapter 3 Terminal base unit (not included)
2 #6 Self-tapping screws 4 Adapter module (not included)
