10
4. TECHNICAL SPECIFICATIONS
INPUTS
Phono Inputs 1 and 2
Line Inputs 1 and 2
Mic Input
48dB gain@1kHz, unbalanced
8dB gain, unbalanced
58
dB gain, servo balanced
OUTPUTS
Headphones
Main Out
Tape Out
typically 125mW@ 1% THD
max +21dBu
typically 0dBu
POWER SUPPLY
Connector type
Mains Voltage
MAX Power Consumption
Fuse
3 pole IEC, grounded
USA / Canada: 100 120V~, 60Hz
Europe: 210 240V~, 50Hz
U.K. / Australia: 240V~, 50Hz
400W
100 120V~ : T4A
210 240V~ : T2AL
PHYSICAL
Dimension
Weight
248(L) 245(W) 102(H)mm (9.76" 9.65" 4.01")
6.3Kg
GENERAL
Stereo Bass
Stereo Treble
Input Gain Adjustment
Signal to Noise ratio (S/N)
Distortion (THD)
Frequency Response
+15dB/ 30dB
20dB 6dB ( 3dB)
>85dB (LINE)
0.1%
20Hz 20KHz ( 2dB)
+15dB/ 30dB
Stereo Middle
+15dB/ 30dB
3.4.1 POWER CORD
You can connect the plug of POWER CORD to the mains. Please check the voltage accepted by the unit
and the voltage available from your AC sockets before connecting the unit to the mains.
21
3.4.2 POWER SWITCH
This switch turns the Mixer ON and OFF. When you turn on the Mixer, both the power indicator and
on front panel will light on.
MAIN
LED
22
3.4.3 AC FUSE HOLDER
The fuse is used to protect the AC supplies circuits of this unit. If the fuse blows, please change the fuse
with same specification. If the fuse continues to blow after replacing, please discontinue using this unit
and ask repair to the qualified technician.
: Don't use wire or copper wire instead of fuse.Warning
3.4.4 DC OUTPUT
You can connect the cable of DC OUTPUT to POWER IN on rear panel.
23
3.4.5 FAN
The fan can accelerate the flow of air to lower the temperature inside power supply box. The inside tem-
determines the fan speed which controls the inside air flowing speed.perature
24
RMS: 2 80W@4
EIAJ: 2 157W@4
Power Amp Out
POWER AMP SECTION
25
Dynamic Power: 2 300W 4
