A SERVICE OF

logo

Let us assume both that our system is already calibrated and that we
have equalized the system for the test port in use. We would then
1. Connect the Short: A Short always appears as a dot at the left-most
edge of the Smith chart’s horizontal axis.
2. Connect a Termination: Now you will see another dot located at the
center (1+j0) of the chart (this assumes a 50-ohm load).
3. Connect the Open: An Open appears as an arc on the chart’s right
edge. This is due to the fringing capacitance of the Open standard
(Figure 8-6).
37xxxE OM 8-9
MEASUREMENTS TRANSMISSION AND REFLECTION
SMITH CHART
SHORT
OPEN
ARC
TERMINATION
Figure 8-6. Smith Chart Display 2