2626
2626
26
ASRock K10N78hSLI-WiFi / K10N78hSLI-1394 Motherboard
EnglishEnglish
EnglishEnglish
English
2.9 eSA2.9 eSA
2.9 eSA2.9 eSA
2.9 eSA
TT
TT
T
AII InterAII Inter
AII InterAII Inter
AII Inter
face Introductionface Introduction
face Introductionface Introduction
face Introduction
NOTE:
1. If you set “SATA Operation Mode” option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or remove
your eSATAII devices to the eSATAII ports while the system is power-on and in
working condition.
2. If you set “SATA Operation Mode” option in BIOS setup to non-RAID mode, Hot Plug
function is not supported with eSATAII devices. If you still want to use eSATAII
function in non-RAID mode, please insert or remove your eSATAII devices to the
eSATAII ports only when the system is power-off.
3. If you want to use the eSATAII HDD as an OS disk, please set “SATA Operation
Mode” option in BIOS setup to non-RAID mode. If you want to use the eSATAII HDD
as a removable data disk, please set “SATA Operation Mode” option in BIOS setup
to RAID mode. If you want to add the eSATAII HDD as a RAID disk, please set “SATA
Operation Mode” option in BIOS setup to RAID mode.
4. Please do not configure your eSATAII HDD as a RAID disk; otherwise, it may affect
the Hot Plug function that eSATAII HDD should have.
5. Please refer to page 28 to 31 for detailed information of RAID mode, non-RAID
mode and AHCI mode.
Connect the SATA data cable
to the orange SATAII
connector
(SATAII_6 (PORT5))
Connect the SATA
data cable to the
eSATAII connector
(eSATAII_TOP)
1. In order to enable the eSATAII port of the I/O shield, you need to connect the
orange SATAII connector (SATAII_6 (PORT5); see p.2/3 No.11) and the eSATAII
connector (eSATAII_TOP; see p.2/3 No.36) with a SATA data cable first.
eSATAII_TOP
How to install eSATAII?
SATAII_6 (PORT5)
