Chapter 4. Administrator Utility
71
Setting Function
Change
Password
Enter the old account password. Enter a new password, and then
reenter the password to confirm it. Blank passwords are permitted.
Or, do not enter anything to leave the password unchanged.
OSD Activation Selects which Hotkey activates the OSD function:
[Scroll Lock] [Scroll Lock] or [Ctrl] [Ctrl].
Since the Ctrl key combination may conflict with programs running
on the computers, the default is the Scroll Lock combination.
Set Logout
Timeout
This function allows you to specify the number of minutes to elapse
before an inactive user is timed out of the OSD. If there is no input
from the user for the specified amount of time, the user will be
logged out automatically. Enter a value from 1–180 minutes, then
click Save. A value of 0 disables this function. The default is 0
(disabled).
Screen Blanker If there is no input from the KVM console for the amount of time set
with this function, the screen is blanked. Enter a value from 1–30
minutes, then click Save. A value of 0 disables this function. The
default is 0 (disabled).
Hotkey
Command
Enables / Disables the Hotkey Command function in case a
conflict with programs running on the computers occurs. The
default is enabled.
Set Beeper When set to ON, the beeper sounds whenever the KVM port is
switched, when activating the Auto Scan mode (see page 114), or
when an invalid entry is made on an OSD menu. The default is ON.
Broadcast
Timeout
If there is no input from the KVM console after initiating a broadcast
command for the amount of time set with this function, the KVM
port is released, allowing it to be accessed by the other KVM
consoles.
To set the Broadcast Timeout value, enter a value from 0–240
seconds, then click Save.
A value of 0 disables the Broadcast Timeout function. The default
value is 5 seconds.
Restore User
Default
Restores the original factory default settings for View Mode (OSD),
Set Port ID, Display Duration, Set Scan, OSD Activation, Set
Logout Timeout, Screen Blanker, Hotkey Command, Set Beeper,
and Set Broadcast Timeout.
