Avaya C360 Manager User Guide 237
IP Route
RIP Version
The router can be configured to operate either
RIP version 1 or RIP version 2 on each IP
interface. The configuration of the RIP version
must be consistent on each subnet. That is, all
routers should be configured with the same RIP
version on their interface to the subnet.
When possible, homogeneous configuration of
the RIP version in the network is
recommended.
•
Rip1 - The router runs regular RIP on that
interface, following the RIP version 1
subnet aggregation rules. That is, it
advertises an aggregate route for the net as
opposed to advertising subnet routes across
the network boundary.
•
Rip2 - The router runs RIP version 2 on
that interface. RIP version 2
advertisements are sent as multicast rather
than broadcast. No route aggregation is
done in RIP version 2. RIP version 2 allows
for Variable Length Subnets Masks
(VLSM), meaning that subnets of the same
net may have masks of different lengths,
and may be of different sizes.
Send Receive Mode
What the device sends on this interface. Values
are:
•
talk-listen - RIP updates contain the entire
routing table.
•
talkDefault-listen - RIP updates contain
only a single entry. This advertises the
router as the default router.
• listen-only - No RIP updates are sent.
Cost
The cost of using this interface. RIP chooses the
route with the lowest total cost (metric) for
each destination.
Default Route Metric
The metric of the default route entry in RIP
updates originated on this interface, if
configured to
SendDefaultOnly.
Table 20-8. RIP Interface Parameters (Continued)
Field Description
