Encore VPx Installation Guide • 08-0311105-00 Rev 00 17
båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
Installation
fåëí~ääáåÖ=smu=áå=~=táÇÉ=pÅêÉÉå=`çåÑáÖìê~íáçå
The figure below illustrates a block diagram of a “triple” wide screen configuration that
includes VPx. Use this diagram for reference in the following procedure. Please note:
• Aux destinations are not shown in the diagram.
• This procedure can be used for wide screen configurations consisting of from 2 to
32 screens. Horizontal, vertical, and “array” blending is set using the Destination
Setup Menu.
• A VP must be used as the “master” processor. Thereafter, either a VP or a VPx
can be used.
• Software version 1.22 (or higher) must be installed first in your Encore Controller,
prior to connecting your VPx processor(s).
Figure 5. Block Diagram, Wide Screen Encore Configuration
PG 2
PVW
PG 1
Projector #1 Projector #2 Projector #3
Program #1 Program #2 Program #3
Preview #1 Preview #2 Preview #3
Controller SC or LC
VP #1
VP or VPx #2
Ethernet Switch
PG 2
PVW
PG 1
PG 2
PVW
PG 1
Scaled
Sources
Unscaled
Sources
M/E Inputs
Unscaled
Sources
Unscaled
Sources
Program
Link
VP or VPx #3
Source
Link
Program
Link
Source
Link
To:
Routers
ScreenPRO-II
PresentationPRO-II
ImagePRO
Note: #1 is VP only, not VPx
Important: Software version 1.22 (or higher)
must be installed in the Controller.
