A SERVICE OF

logo

Open as PDF
next previous
XLB-4725A
4-8
5. Using a pry bar and shoring, unweight the cylinder end. Remove pivot pin (4)
and spacers (5).
6. Lower the free end of cylinder (6) onto support shoring or a lifting strap.
7. Repeat steps 4 through 6 at the opposite end of the cylinder.
8. Lift the lower end of the cylinder from its pivot block. Use an overhead lifting
device and lifting straps and/or a lift truck to remove the cylinder.
9. After repairing the hydraulic cylinder, reinstall the cylinder in the reverse order
of removal.
10. Power up the hydraulic system and check for leakage. Tighten hydraulic fittings
as needed.
11. Bleed entrapped air from the hydraulic cylinder according to instructions in
paragraph 4-4.
NOTE: Do not tamper with the cylinder counterbalance valves. If the
counterbalance valves need adjustment, contact the Bil-Jax Service
Department at 419.445.9675.