A SERVICE OF

logo

Open as PDF
next previous
18 - EN
Starting the Program
1.Pressthe“Start/Pause/Cancel”buttonto
start the program.
2.TheStart/Pause/Cancelbuttonwilllightup
to indicate that the program has started.
Progress of program
Progressofarunningprogramisshown
through the program follow-up indicator.
At the beginning of each program step, the
related lamp will light up and the lamp of the
completed step will turn off.
“Drying”:
- Drying level will be illuminated during the
whole drying process until the dryness
reaches“DampDry/ReadytoIron”.
“Damp Dry / Ready to Iron”:
- Lamp lights when the dryer reaches the
“DampDry/ReadytoIron”stepandremains
lit until the next step.
“Regular Dry / Ready to Wear”:
- Lamp lights when the dryer reaches the
“RegularDry/ReadytoWear”stepand
remains lit until the next step.
“End / Anticrease”:
- The lamp lights when the program comes
to an end and the anti-creasing function is
activated.
C If more than one lamp lights or flashes
constantly, it means that there is a
malfunctionorafailure(Pleasesee
Troubleshooting).
Changing the program after the
program has started
PressandholdtheStart/Pause/Cancelbutton
for around 3 seconds to Cancel the program
currently running.
Select another program by rotating the
program knob.
Pressthe“Start/Pause/Cancel”buttonagain
to start the new program.
C The program which is selected first will go
on even if the program selector knob is
moved and another program is selected
whilethedryerisoperating.Youmust
cancel the current program to change the
drying program.
A As the inside of the dryer will be
excessively hot when you cancel the
program when the dryer is running,
activate the ventilation program to cool it
down.
A If the dryer is stopped during any drying
program, and if the position of the
program selector knob is changed, a tone
willbeheard(iftheCancelAudioWarning
functionisnotselected).Thedryerwill
notstarteveniftheStart/Pause/Cancel
button is pressed, unless the program
selector knob is returned to the initial
program. The paused program must be
cancelled in order to change the drying
program.
Adding/removing laundry in stand-by
mode
In order to add or take out laundry after the
start of the program;
1.PresstheStart/Pause/Cancelbuttonto
switchthedryertoPausemode.thedrying
process will stop.
2.OpenthedooratthePausepositionand
close it again after adding or taking out
laundry.
3.Pressthe“Start/Pause/Cancel”buttonto
restart the program.
C Laundry may be added or taken
out during a drying process, but
interrupting drying continuously will
extend the program's time and increase
energy consumption. Therefore, it is
recommended to add all laundry before
the drying program is started.
Auxiliary functions
Cancel Audio Warning Signal
Yourdryerwillsendoutatonewhenthe
program comes to an end. If you do not want
to hear this, you need to press the Cancel
Signal button. The relevant lamp will light
when this button is pressed and the tone will
not activate when the program ends.
C Youcanselectthisfunctioneitherbefore
or after the program starts.