46 en | Subsystem Maintenance RAID Subsystem DVA-08K | Installation Manual
F.01U.027.797 | V2 | 2008.08 Bosch Security Systems
Fig. 6.2 Push Back the Module Clips on the Sides of the DIMM Socket
3. Gently retrieve the DIMM module out of the DIMM socket. (See Figure 6.2)
4. Insert the DIMM module into the DIMM socket. Align the DIMM module with the DIMM
socket. Once aligned, gently push the DIMM module into the socket. The white clips on
the sides of the socket will close automatically and secure the DIMM module into the
socket.
Fig. 6.3 Insert the DIMM Module
5. Reinstall the controller module. After the DIMM module has been properly installed, the
controller module must be reinstalled. To do this, align the controller module with the
controller module bay. Then gently push the controller module in the controller bay.
Carefully push the controller until you feel the contact when the board edge connectors
are mated to the backplane. Do not use force. If unusual contact resistance is felt, try it
again. Next secure the controller module into the subsystem by fastening the hand
screws on the sides.
NOTICE!
When replacing a DIMM, the whole subsystem needs to be powered down. Therefore, when
replacing a DIMM, you should carefully select the time when the replacement will be made in
order to minimize the overall disruption to service.
