English – 49
1
2
11
3
1
2
Reparation instructions
Adjusting cutting height area
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm
(3/16") the other fixed cutting heights will also be
raised by the same amount.
Remove the right-hand fender.
Adjusting cutting height
• Loosen the nuts on the height setting arm.
• Adjust so that the distance between the stop for
the lowest height setting and the protective
frame is 5 mm (3/16").
• Tighten the nuts.
• Check that the parallelism has not changed. If it
has changed, the parallelism must be
readjusted again.
• Check and adjust the cutting unit’s ground
pressure as set out (see “Checking and
adjusting cutting unit ground pressure”) if
necessary.
• Fit the nose.
IMPORTANT INFORMATION
The parallelism and height must be
adjusted again when changing the cutting
unit.
