Sending the Same Document to Several Recipients (Sequential Broadcasting)
4-13
Sending Faxes
4
2
Adjust any necessary settings for your document.
• Press [Image Quality] to select the fax resolution. (See "Adjusting the Image Quality
(Fax Resolution)," on p. 4-5.)
• Press [Exposure] to select the scan density. (See "Adjusting the Exposure (Scan
Density)," on p. 4-6.)
3
Enter the fax/telephone numbers you want to send to.
● To use one-touch speed dialing:
❑ Press the one-touch speed dialing key(s).
● To use coded speed dialing:
❑ Press [Coded Dial] ➞ use the numeric keys to enter the two-digit code.
NOTE
Repeat step above to enter the other codes if necessary.
● To use regular dialing:
❑ Use the numeric keys to enter the fax/telephone number ➞ press [Set].
To review the numbers you have entered, press [ ] or [ ].
4
Press [Start].
If you are using the platen glass, you will be prompted when the page has been
scanned. Place the next page (for a multipage document) ➞ press [Start]. To start
sending, press [Set].
NOTE
•
Only one broadcasting job will be active at any given time.
•
To cancel sending, press [Stop/Reset] ➞ follow the instructions in the LCD. When you
press [Stop/Reset], sending to all recipients will be canceled. You cannot cancel sending
to only one recipient. (See Chapter 7, "System Monitor," in the Basic Guide.)
