K4G120 Installation Instructions
8
Display Installation
Faceplate Positioning
1. Loosen height adjustment screws for each faceplate to
adjust height. (See Figure 8)
2. Adjust faceplates to desired height. (See Figure 8)
IMPORTANT ! : In order to install displays with no gap in
between displays, distance between faceplates must
equal the height of each display. (See Figure 9)
NOTE: Faceplates may be positioned a minimum of 12" apart
and a maximum of 16" apart. (See Figure 9)
3. Tighten height adjustment screws to lock display’s position.
(See Figure 8)
Figure 8
Figure 9
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the K4G120 mount up to (and
including) the display does not exceed 15 lbs (6.8 kg) per
display.
CAUTION: Using screws of improper size may damage
your display! Proper screws will easily thread into display
mounting holes.
NOTE: Supplied screws (M, N and P) may not fit properly for
all displays. See display’s operating instructions for
details.
Flush Mounting Holes
IMPORTANT ! : Lower display must be installed before
installing upper display!
1. Using Phillips screwdriver, carefully install two M4 x 12mm
Phillips pan machine screws (P) into the upper mounting
holes on the display. Thread screws completely into display,
then back out 3 complete turns. (See Figure 10)
Figure 10
2. Pick up and align display so that screws (P) (installed on the
back of the display in the previous step) fit into the mounting
holes on the faceplate. Lower the display firmly into place.
(See Figure 10)
3. Using Phillips screwdriver, install two M4x12 mm Phillips
pan machine screws (P) through the lower mounting holes
on faceplate into the display. (See Figure 11)
2
2
1
3
1
3
Min 12”
Max 16”
faceplate
(array arm not shown for clarity)
(P) x 2
1
