8-14 AlphaServer GS80/160/320 User’s Guide
8.7 SCM Command-Line Interface
The system control manager supports setup commands and commands
for managing the system. See Table 8–1. For an SCM commands
reference, see the AlphaServer GS80/160/320 Firmware Reference
Manual.
Table 8–1 SCM Commands
Command Description
Clear {alert, error}
Clears firmware or hardware state (alert).
Clears SDD and TDD error logs (error).
Crash
Forces a crash dump at the operating system level.
Disable {alert, remote}
Disable system alerts or remote access.
Enable {alert, remote}
Enables system alerts or remote access.
Erase
Erases the current screen.
Fault
Emulates the control panel Fault button.
Halt
Halts the operating system.
Hangup
Terminates a remote session, disconnecting the
modem.
Help
Provides SCM command information
Init
Prepares modem to send alerts and receive
incoming calls.
Power
Directs the system control manager to suply power
to the processors, memories, and I/O modules in
the system.
Quit
Exits the SCM command-line interpreter and
returns control to the COM1 port.
Reset
Resets the system.
Set alert
Specifies a string that defines the time to wait for
the remote pager to respond to a dial-out, and a
message to be sent to the remote pager.
