A SERVICE OF

logo

Removal and Replacement Procedures 2-17
Diskette Drive
To remove the diskette drive:
1. Perform the preparation procedures. See Powering Down the Server earlier in this
chapter.
2. Open the front bezel (tower model only). See Front Bezel earlier in this chapter.
3. Remove the large access panel. See Large Access Panel earlier in this chapter.
4. Disconnect all cables from the diskette drive.
5. Remove the two T-15 screws and washers securing the diskette drive to the chassis .
6. Slide the diskette drive out the front of the chassis .
2
1
1
Figure 2-13. Removing the diskette drive
Reverse steps 1 through 6 to replace the diskette drive.