3-14 Compaq ProLiant ML370 Maintenance and Service Guide
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of Problem Recommended Action
*1724 - Slot x Drive
Array—Physical
Drive Position
Change(s) Detected –
Logical drive
configuration has
automatically been
updated
None Drive change Indicates that logical drive
configuration has been updated
automatically following physical
drive position changes. Press F1
to resume.
*1726 - Slot x Drive
Array—Array
Accelerator Memory
Size Change
Detected
None Configuration update Indicates Array Accelerator
configuration has been updated
automatically due to
replacement of Array
Accelerator (or controller) with
one having different memory
size. Press F1 to resume.
*1727 - Slot x Drive
Array—New Logical
Drive(s) Attachment
Detected. If more
than 32 logical
drives, this message
will be followed by:
Auto-configuration
failed: Too many
logical drives.
None Additional drives This message indicates that the
controller has detected an
additional array of drives that
was attached when the power
was off. The logical drive
configuration information has
been updated to add the new
logical drives. The maximum
number of logical drives
supported is 32. Additional
logical drives will not be added
to the configuration. Press F1 to
resume.
1729 - Slot 1 Drive
Array—Disk
consistency
initialization in
progress—RAID 4/5
performance may be
lower until Auto
Reliability Monitoring
has completed
automatic parity
consistency
initialization
None Initial RAID configuration in
progress.
This message is normal
following the initial
configuration of RAID 4 or
RAID 5 logical drives. This POST
message will go away and
performance of the controller
will improve after the parity data
has been initialized by ARM (an
automatic process than runs in
the background on the
controller).
1730 - Fixed Disk 0
does not support
DMA Mode.
None Fixed disk drive error detected Run the System Configuration
Utility and correct.
continued
