TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch on
the back of the appliance is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
• Toturntheapplianceon,pressthe button (g. 7).
The message “Heating up Please wait” is displayed.
After heating, the message “Rinsing” is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance has reached the required temperature when a
message is displayed indicating the coee taste and quantity.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts.
Avoid contact with splashes of water.
To turn the appliance o, press the
button (g. 7).
The appliance performs a rinse cycle, then the message
“Turning o underway Please wait” is displayed and the
appliance goes o.
Please note!
If the appliance is not used for an extended period, switch o
the machine at the main switch (g. 2).
Important!
To avoid damaging the appliance, never switch the appliance
o at the main switch before it has been turned o using the
button.
MENU SETTINGS
When you access the programming menu by pressing the MENU/ESC
button, the following menu items are available:
Rinsing
Use this function to deliver hot water from the spout to heat the internal
circuit and make the coee delivered hotter.
To enable the function, proceed as follows:
1. Press the MENU/ESC button to enter the menu;
2. Press the MILK or CAPPUCCINO button (g. 8) until
“Rinsing” is displayed;
3. Press the button. The message “Conrm?” is
displayed;
3. Press the button (g. 3). Hot water ows out of
the spout, heating the internal circuit and making the
coee delivered hotter.
Descale
For instructions on descaling, see page 17.
Adjust time
To adjust the time on the display, proceed as follows:
1. Press the MENU/ESC button to enter the menu;
2. Press the MILK or CAPPUCCINO button (g. 8) until
“Adjust time” is displayed;
3. Press the button (g. 3);
4. Press the MILK or CAPPUCCINO button (g. 8) to change
the hours;
5. Press the button to conrm;
6. Press the MILK or CAPPUCCINO button (g. 8) to change
the minutes;
7. Press the button to conrm.
This sets the time. Press the MENU/ESC button to exit the
menu.
Auto-o
The auto-o time can be changed so that the appliance
switches o after 15 or 30 minutes, or after 1, 2 or 3 hours.
To re-programme Auto-o, proceed as follows:
1. Press the MENU/ESC button to enter the menu;
2. Press the MILK or CAPPUCCINO button (g. 8) until
“Auto-o” is displayed;
3. Press the button;
4. Press the MILK or CAPPUCCINO button (g. 8) until the
desired operation time is displayed (15 or 30 minutes, or
1, 2 or 3 hours);
5. Press the button to conrm;
6. Press the MENU/ESC button to exit the menu.
Auto-o is programmed.
Auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coee immediately.
Please note!
To enable this function, the time must already have been set
correctly.
