PCI30FG User Manual
Eagle Technology © Copyright 2002 3
2 Installation
This chapter describes how to install and configure the PCI30FG for the first
time. Minimal configuration is necessary; almost all settings are done through
software. The PCI BIOS will assign an I/O base address and interrupt level.
Package
PCI30FG package will contain the following:
• PCI30FG PCI board
• EDR Enhanced Software Development Kit CD-Rom
Hardware Installation
This section will describe how to install your PCI30FG into your computer.
• Switch off the computer and disconnect from power socket.
Failure to disconnect all power cables
can result in hazardous conditions, as
there may be dangerous voltage levels
present in externally connected
cables.
• Remove the cover of the PC.
• Choose any open PCI slot and insert PCI30FG.
• Insert bracket screw and ensure that the board sits firmly in the PCI
socket.
• Install digital I/O connector cable.
• Replace the cover of the PC.
• Reconnect all power cables and switch the power on.
• The hardware installation is now completed.
