Epson PowerLite 732c Projector
10 - Epson PowerLite 732c Projector 2/05
Starting the Projector with a Password
Note:
You must unplug the projector and then plug it back in to enable
password protection.
When the password function is enabled, you see this screen
when you plug in and turn on the projector:
Hold down the
Num button on the remote control as you use
the numeric keypad to enter the password. Once you enter the
password correctly, the screen closes, and projection begins.
If the password is not correct, you see the message
Wrong
password. Please try again
. If you enter an incorrect
password three times in succession, you see the message
The
projector’s operation will be locked. Request code xxxxx
and the projector switches to standby mode for approximately
5 minutes. Write down the request code. Then disconnect the
projector’s power cord from the electrical outlet, reconnect it,
and turn the projector back on. When you see the Password
Protect Release screen, enter the correct password.
If you have forgotten the password, contact Epson for assistance
and give them the request code number that appears in the
Password Protect Release screen.
If you enter an incorrect password 30 times in a row, the
projector remains locked and you must contact an authorized
Epson servicer to unlock it.
Disabling the Projector’s Buttons
When you enable the Operation Lock function, all the
projector’s buttons are disabled except the P
Power button.
1. Press the
Menu button.
2. Select the
Setting menu and press Enter.
3. Select
Operation Lock and press Enter.
4. Select ON and press Enter. Then select Yes and press Enter
to confirm the setting.
5. Press the
Menu button to exit the menu system.
Note:
You can cancel Operation Lock by pressing the projector’s
Enter
button for 7 seconds.
Projector Status Lights
The lights on top of the projector indicate the projector’s status
and let you know when a problem occurs.
Power
light
Lamp
light
Temperature
light Description
Flashing
green
Off Off The projector is warming up.
Wait for the image to appear.
Green Off Off The projector is operating
normally.
Flashing
orange
Off Off The projector is cooling
down. Wait for the light to
stop flashing and remain
orange before unplugging it.
Red Flashing
red
Flashing red There is an internal error in
the projector. Turn off the
projector and unplug it.
Contact Epson for help.
Red Off Flashing red There is a problem with the
fan or a sensor. Turn off the
projector and unplug it.
Contact Epson for help.
Red Flashing
red
Off The lamp is burned out,
broken, or not installed
correctly, or the lamp cover is
open. Close the cover or
replace or reseat the lamp, if
necessary, as described on
page 12.
Red Flashing
orange
Off Replace the lamp with a new
one as soon as possible. See
page 12 for instructions. If
you continue to use the lamp,
there is a risk it may break.
Power light
Lamp light
Temperature
light
