79
MaintenanceMaintenance
The projector has a built-in counter which keeps track of the lamp
operating time. When the cumulative operating time reaches a certain
point, it causes the replacement warning message to be displayed.
Therefore, the counter needs to be reset after the lamp has been replaced
with a new one. You can do this using the configuration menu.
Use the remote control to carry out the operations for resetting the lamp
operating time.
PROCEDURE
Connect the power cable, turn on the projector's
power, and then press the [Menu] button on the
remote control.
The configuration menu will be displayed.
Select "Reset Lamp Timer" from the "About" menu
and then press the [Enter] button.
Select "Yes" and then press the [Enter] button.
The lamp operating time will then be reset.
Resetting the Lamp Operating Time
TIP
Do not reset the lamp operating time except after the lamp has been
replaced, otherwise the lamp replacement period will not be indicated
correctly.
1
Menu
A/V Mute
E-Zoom
Freeze
Enter
Remote Control
2
Frequency
Video Source
V ---.--Hz
Reset Lamp Timer
H ---.--kHz
Lamp 1400H
SYNC Mode
SYNC Polarity
------
H ------
Resolution
Refresh Rate 0.0 Hz
0x 0
Computer
Input Signal RGB
Execute
:
:
:
:
:
:
V ------
:
:
:
:
:
3
Reset Lamp Timer
Execute?
YES
NO
Reset Lamp Timer
Execute?
YES
NO
